Stop the carriage assembly into the left reversing position.
2
Remove two screws (1) on each side of the machine.
3
Remove the screws (2) over the entire length of the selection jack bed.
4
Push the intermediate sliders (3) into their highest position.
5
Push the selection jacks (4) into their highest position.
6
Starting from one side, lift the selection jacks at their highest end, and push simultaneously the wire (5) from the accessories, between the selection jack bed and the selection jack. Carry this out over the entire length of the selection jack bed. The wire must be pushed in so that the working butts of the selection jacks stick out so high that they touch neither the intermediate slider nor the needle bed.
7
Push the selection jack bed to the side. The front bed to the left and the rear bed to the right. (Use a rubber mallet, if necessary.)
8
Remove the selection jack bed.
9
When mounting the selection jack bed, make sure that it rests on pin (6).
