Stop the carriage assembly into the left reversing position.
2
Remove needle bed. Lay the needle bed on a flat surface (e.g. workbench or table).
3
Push the intermediate sliders (1) into their highest position.
4
Remove two screws (2) on each side of the machine.
5
Remove the screws (3) of the clamping pieces (4) over the entire length of the selection jack bed.
6
loosen both grub screws (5) at each clamping piece. Move clamping piece to the side and remove it.
7
Push the selection jacks (6) into their highest position.
8
Starting from one side, lift the selection jacks at their highest end, and push simultaneously the wire (7) from the accessories, between the selection jack bed and the selection jack. Carry this out over the entire length of the selection jack bed. The wire must be pushed in so that the working butts of the selection jacks stick out so high that they touch neither the intermediate slider nor the needle bed.
9
Remove the selection jack bed.
10
When mounting the selection jack bed, make sure that it rests on pin (8).
11
Mounting the clamping pieces: Insert clamping piece and push it to the side. Secure it with the screw (3) and then tighten the grub screws (5).
