Releasing needle bed

    1
    Transfer all stitches of the needle bed to be removed or positioned vertically to the other needle bed.
    2
    When the carriage assembly is in the left reversing position, stop the machine with the engaging rod. If a central lubrication is present, the carriage must be in the left reversing position.
    3
    In the Intervene Manually II window tap the Release Drive Brake button and slide the carriage assembly to the left up to the stop point.
    Intervene Manually II ->  Release Drive Brake
    4
    With CMS 830 C, CMS 520 C+:
    Use the needle bed swivel support (10) (special attachment ID 268 961).
    It prevents the selection jacks from getting damaged when the needle bed is positioned at an angle.


    On the left and right-hand sides of the needle bed, position a needle bed swivel support (10) on the cover of the carriage guide bar and push it inward until the selection jack bed.
    5
    Remove two screws (2) on each side of the machine.
  1. Unscrewing the needle bed (on the right: CMS 830 C, CMS 520 C+)
    2. 6
    With CMS 822, CMS 803:
    Unscrewing the rear needle bed for gauges E 10 - E 18
    Remove the screws (3). Push the connection (4) to the side. While doing so, the impulse sensor rail is pushed to the side.
Link of the impulse sensor rail
Link of the impulse sensor rail