Maintenance

In this menu, you set up:

Vacuum

Switch on or off the suction of the whole needle bed
Number of courses with and without suction (1 course = 2 rows)

This menu point is only available if the suction is switched on.

Cleaning

Clean Selection Systems

Carriage direction for cleaning course
Quantity of courses till the needle selection systems get cleaned (1 course = 2 rows)

Clean Selection Systems

Lubricating

Manual Lubricating

Set the quantity of system run-throughs until the next oil lubrication is required.
Switch on or off the stop motion depending on whether the machine is to stop after the specified quantity of system run-throughs.
Displays the quantity of the remaining system run-throughs until the next oiling of the needle bed.

Adjust central lubrication:

Select the operating mode for the automatic lubrication.
Set the quantity of system run-throughs until the next oil lubrication is required.
Setting of the number of lubrication procedures after which the entire needle bed is to be lubricated.
Displays the quantity of the remaining system run-throughs until the next oiling of the needle bed.

Lubricating

Set the quantity of system run-throughs until the next oil lubrication is required.
Switch on or off the stop motion depending on whether the machine is to stop after the specified quantity of system run-throughs.
Displays the quantity of the remaining system run-throughs until the next oiling of the needle bed.