Alarms of Machine Events

In this area you configure the threshold values for machine events in the alarm system.

1: In the Message area section of the Configuration window in the Stop motion number... field, enter one or more combinations from the machine status numbers and stop motion error numbers of the machine which the PPS is to interpret as a trigger regarding a stop motion.
Format: Machine status number[:[-]Error number,[-]Error number],...]; Machine status number [:[-]Error number,[-]Error number,...];… .
If only the machine status number is indicated, then all the error numbers will be considered for a message or alarm.

A machine state can also be considered only in case of simultaneous occurrence of message numbers. You enter the message numbers behind a machine state after a colon separated by a comma.

Una macchina risulta sempre in uno stato, rappresentato a sua volta dallo stato della macchina e al quale è assegnato un numero.
Eventi di stato MC e Stato macchina: Colori e simboli
Anche i messaggi emessi dalla macchina sono contrassegnati da un numero.
Help to Error Messages.
Questi messaggi si verificano durante uno stato della macchina.

Potete far scattare un messaggio PPS o un allarme PPS, quando la macchina assume uno stato o si verifica una determinata combinazione di stato e messaggio.

Combinations that already occurred can be found in the Event list report for EVENT_TYP=2 in the EVENT_PARAM field.
If no error numbers are indicated, then the machine status is always considered.
If a minus appears in front of the error number, it will be excluded and will not be considered for a message or alarm.

Example:

6;
Consider all message about Stop: Needle Position Sensor (6).
You want to be informed about all needle position sensor stops (6)
9:7250;
Consider the 07250 message only with Stop: Other (9)
With a machine stop for other reasons (9), the error number 7250 is to be on simultaneously for a message
10:-608,-1007,-10252;
Consider all message about Stop: Shock Stop Motion (10) except the 00608, 01007 and 10252 messages.
With a shock stop motion (10), you only want to be informed if it does not occur in combination with the error numbers 608, 1007, and 10252.
Via the Event list in the Excel report or in the report integrated in the PPS you can filter by EventType=2 and EventID=2...32002. The Event ID corresponds to the machine state number.
In the EVENT_PARAM column, you can see which error numbers the machine delivers and determine the appropriate numbers for filtering.
The error numbers are also displayed in the message area of the machine.
You can see the message numbers in the Stop Motions and Warnings dialog box at the machine.
Or here: Help to Error Messages
Note, that OKC and EKC machines use different numbers for the same message.

1: Select the Save button.

In the Configurazione di notifiche personali dell'utente mask, you can book the events that are described below via the Machine events event.

The alarm configuration of machine events will be implemented immediately.