Clamping and cutting

YGC: n / n ;

Yarn carrier - home position (the yarn carrier is allocated to the clamping position with the same number) (yarn carrier 1 - clamping position 1, yarn carrier 2 - clamping position 2, etc.)

Do not use this command with the CMS ADF, but instead YGCX:n,n/n,n; see chapter "Yarn carrier"

S0YCR0

Empty courses until all yarn carriers are at the area of use (SEN or #L, #R)

Y-1A:C;

Clamping and cutting the yarn of yarn carrier 1A

Y-1A:R;

The clamp for the yarn of the yarn carrier 1A will be opened

Y-1A:R n;

The clamping device for the yarn of the yarn carrier 1A is open after n stitch rows (n=number -1) Value range: 0-120
0 = clamp for yarn carrier 1A is not open
1 = clamp for yarn carrier 1A is open

Y-RALL

All clamps in carriage direction will be opened, as defined in YG.

Y-RALL(n,m)

The clamp of the yarn carriers n, m will not be opened by the command Y-RALL.
Example: Y-RALL(1A,2A)

You can open the clamp of yarn carrier 1A by the command Y-1A:R;.

Y-CR0 ¹

"Clamping and cutting" function out of operation (deleted automatically with EALL)

Y-CR1 ¹

"Clamping and cutting" function in operation (deleted automatically with EALL)

Y-CR[0/1][L/R]

Activate/deactivate clamping/cutting
0 = deactivated, 1 = activated
L = left, R = right

Y:1K;

Yarn carrier 1 knits and is then clamped and cut

NCC=n

Only for machines with clamping-cutting bed:
Control of the clamping depth of the cutting needles, n=-25...0…25.
Default setting: n=0
e.g.: sink the cutting needles by 5 steps deeper: NCC=5