Mounting the yarn guide device

Push the supports of the yarn guide device upward together with another mechanic to prevent the supports from jamming.

  1. The main switch is set to 0 and secured against being switched on again.
    1
    Loosen the screws (1) on both machine sides.
  1. Supports for the yarn guide device
    2. 2
    Push the left and right supports of the yarn guide device upward simultaneously until the distance between the bobbin board and the yarn guide device is 50 to 55 cm.
    3
    Retighten the screws (1) on both sides of the machine.

Mounting the rear yarn guide bar and the additional bobbin boards

The equipment of your machine can deviate from this description depending on the machine type (type of machine, scope of supply, special attachments).

    1
    Remove both screws on the left and right sides of the machine.
    2
    Align the rear yarn guide bar (4) horizontally and screw tight again.
    3
    Connect the yarn guide bars with the support (5).
    4
    Hook in both additional bobbin boards (6).