Detailed description

Repair yarn breakage:

    1
    At which yarn carrier did the yarn breakage occur?
    2
    Release the relevant yarn carrier.
    Tap on the required yarn carrier. The icon changes from to .
    Tap the yarn carrier again. The icon changes from to .
  1. The yarn carrier plunger is switched off.
    2. 3
    Repeat step 2 if a yarn breakage occurred with several yarn carriers.
    4
    Open covers.
    5
    Push the respective yarn carrier by hand out below the carriage.
    6
    Thread-up yarn carrier.
    With a friction feed wheel: Switch on the respective feed wheel so that the yarn is running easily over the roller. Tap on the corresponding key Feed wheel.
  2. The feed wheel is switched on for 60 seconds.
    3. 7
    Switch on again the yarn carrier plunger.
    Select the yarn carrier (in the clamping and cutting bed) on the touch screen .
  3. The yarn carrier plunger is switched on.
    4. 8
    Push the respective yarn carrier by hand below the carriage.
  4. It is positioned exactly if you here a "click". The yarn carrier is in the correct position below the carriage.
    5. 9
    Lead the yarn end opposed to the carriage direction.
    10
    Hold the yarn end outside the danger zone (carriage)
    11
    Push the carriage by hand until the yarn is fixed in the fabric.
    12
    Cut-off the yarn end.
    13
    Tap on the button if you want to start another fabric (အထည္ကို ျပန္လည္စတင္ရန္).
    The machine establishes a defined state and restarts the fabric after confirming. The piece counter does not count down because the actual fabric is defective.
    14
    Confirm the remedy of the yarn breakage (အတည္ျပဳၿပီး ပိတ္ပါ).
  1. The yarn breakage is repaired.

To continue production, close the covers and pull up the engaging rod.