Dismantling thread clamping and cutting device

    1
    Place carriage on opposite side.
    2
    Switch off main switch and wait until machine is currentless.
  1. Linking additional needle bed
    2. 3
    Remove link (1) at front and back. Use the special hexagon screwdriver from the accessories for this purpose.
  2. Cover of thread clamping and cutting device
    3. 4
    Remove cover (3) by removing screws (2).
  3. Cable and screws of thread clamping and cutting device
    4. 5
    Disconnect both plugs (4).
    6
    Remove the screws (5).
    7
    Take out thread clamping and cutting device.