Lubricating

Ръчно Смазване

This button is active if the machine is equipped with central lubrication.

Switch on or off the central lubrication.

Active button = The central lubrication is switched off.

If the central lubrication is switched off you must lubricate the needle bed and jack bed manually.

Inactive button = The central lubrication is switched on.

Системни Ходове до Процеса на Смазване

• Set the quantity of system run-throughs until the next oil lubrication is required (n=1-65535).
• Displays the quantity of the remaining system run-throughs until the next oiling of the needle bed.

Спиране след Брой Системни Повторения

Active button = The machine stops after reaching the system run-throughs.
At the display appears the message Lubricate needle bed.

Check the oil collection tank

• Set quantity of days until the next control of the oil collection tank (n=1-180)
• Display of the time (in days) until the next control of the oil collection tank.

Ръчно Смазване

Active button = The central lubrication is switched off.

If the central lubrication is switched off you must lubricate the needle bed and jack bed manually.

Inactive button = The central lubrication is switched on.

Централно смазване

Switch on or off the central lubrication.

If the central lubrication is switched off you must lubricate the needle bed and jack bed manually.

If you tap on the icon , you can select one of the following options:

• Първоначално Смазване
• STOLL Спецификации
• Потребителски Опции

Първоначално Смазване

This setting is used for the initial lubrication of a new machine at the Stoll factory. The values cannot be modified.
Caution: risk of soiling the fabric.

Select this setting for approx. 15 minutes:

• after a thorough cleaning of the needle bed (12 to 26 weeks)
• with a machine, which has been out of operation for a longer period of time
• after a gauge conversion

STOLL Спецификации

This setting can be used for production. The values cannot be modified.

Потребителски Опции

The following buttons are activated, the values can be modified:

• Смазване на Плетачната Зона След
• Смазване на Цялото Иглено Легло След

Attention
An improper setting could lead to insufficient oiling. Ensure that the central lubrication applies sufficient oil to the needle bed.

Смазване на Плетачната Зона След

Системни Ходове

Set the quantity of system run-throughs until the next oil lubrication is required (n=1-65535).

Смазване на Цялото Иглено Легло След

Процеси на Смазване

Setting of the number of lubrication procedures after which the entire needle bed is to be lubricated.

Системни Ходове до Процеса на Смазване

Displays the quantity of the remaining system run-throughs until the next oiling of the needle bed.