Lubricating

Manual Lubricating

This button is active if the machine is equipped with central lubrication.

Switch on or off the central lubrication.

Active button = The central lubrication is switched off.

If the central lubrication is switched off you must lubricate the needle bed and jack bed manually.

Inactive button = The central lubrication is switched on.

System Run-throughs Until Lubricating Process

• Set the quantity of system run-throughs until the next oil lubrication is required (n=1-65535).
• Displays the quantity of the remaining system run-throughs until the next oiling of the needle bed.

Stop Motion after Quantity of System Run-throughs

Active button = The machine stops after reaching the system run-throughs.
At the display appears the message Lubricate needle bed.

Check the oil collection tank

• Set quantity of days until the next control of the oil collection tank (n=1-180)
• Display of the time (in days) until the next control of the oil collection tank.

Manual Lubricating

Active button = The central lubrication is switched off.

If the central lubrication is switched off you must lubricate the needle bed and jack bed manually.

Inactive button = The central lubrication is switched on.

Central Lubrication

Switch on or off the central lubrication.

If the central lubrication is switched off you must lubricate the needle bed and jack bed manually.

If you tap on the icon , you can select one of the following options:

• Initial Lubrication
• STOLL Specifications
• User Settings

Initial Lubrication

This setting is used for the initial lubrication of a new machine at the Stoll factory. The values cannot be modified.
Caution: risk of soiling the fabric.

Select this setting for approx. 15 minutes:

• after a thorough cleaning of the needle bed (12 to 26 weeks)
• with a machine, which has been out of operation for a longer period of time
• after a gauge conversion

STOLL Specifications

This setting can be used for production. The values cannot be modified.

User Settings

The following buttons are activated, the values can be modified:

• Lubricate Knitting Area After
• Lubricate Whole Needle Bed After

Attention
An improper setting could lead to insufficient oiling. Ensure that the central lubrication applies sufficient oil to the needle bed.

Lubricate Knitting Area After

System Run-throughs

Set the quantity of system run-throughs until the next oil lubrication is required (n=1-65535).

Lubricate Whole Needle Bed After

Lubrication Processes

Setting of the number of lubrication procedures after which the entire needle bed is to be lubricated.

System Run-throughs Until Lubricating Process

Displays the quantity of the remaining system run-throughs until the next oiling of the needle bed.