Changes in version 2.3[Es wird ein veralteter Stand übersetzt]

Software version:

• OKC: V_OKC_005.000.000_STOLL
• M1: M1plus V. 6.0

The most important changes in this version:

• New knitting specifications (chapter knitting specifications):
• $ : Symbols written after the & move needles to the split stitch position
• # : Holding-deep when transferring: symbols written after the # move needles to the receiving position
• UXSn#m; : Transferring and holding-deep simultaneously, e.g. S:UXST#A-+;
  n= jacquard symbol, transferring
  m= Jacquard symbol, holding-deep
  #= symbols written in front of the # move needles to the delivering position,
  symbols written after the # move needles to the receiving position
• $$n-m; : Stitch via split curve front, rear stitch.
  specification stitch via split curve impossible with tuck (e.g. $$%A-0)

Commands for machine with belt take-down:

• Belt take-down (chapter Fabric take-down):
• WB=n : Belt speed n (0-30) [mm/s]
  0= lowest speed, 30= highest speed
• WBFn : Call up belt take-down function n (n=1-50)
  (From Setup2)
• WBOPEN : Open belt take-down
• WBˆn : Turn back of the belt take-down
  n (1-3)

New counters

• More counters (chapter counters)
• #MCC=0 : Clamping and cutting bed on the left and right available
• #MCC=1 : Clamping and cutting bed on the left and right not available
• #MCC=2 : Clamping and cutting bed on the right available
• #MCC=3 : Clamping and cutting bed on the left available
• #MTCCW : Coupling width in inches (tandem with comb)