Changes in version 2.4[Es wird ein veralteter Stand übersetzt]

Software version:

• OKC: V_OKC_006.000.000_STOLL
• M1plus V. 6.3

The most important changes in this version:

• New counters (chapter Counter):
  RS20-RS39: Additional cycle counters for Setup2 patterns
• Commands for the holding-down jacks divided into two subchapters (chapter Holding-down jacks)

Supplements for ADF:

• Plating index: The maximum number has been raised from 9 to 100.
• Command Y-1A:PIn;
  The plating index n is allocated to the yarn carrier 1A (n=1-100)
  (Inverse Plating between the systems)
• Command YX:nP; : The yarn carrier n is used as a plating yarn carrier
  Inverse plating in one system (Stoll-ikat plating®)
  also possible:
  YX:nP!; The plating yarn carrier n is stopped outside of the SEN area.
  YX:nPK; The plating yarn carrier n is knitting, and will finally be clamped, and cut
• Command Y-1A:PW:m=PIn,m=PIn;
  jacquard-controlled plating indication
  The yarn carrier 1A changes the insertion position depending on the jacquard symbols
• Command YX:nQ;The yarn carrier n is used as a weft yarn carrier
  Further Possibilities:
  YX:nQS;The weft yarn carrier n follows the selected needles
  YX:nQH;The weft yarn carrier returns to HOME position
• Command Y-n:MAE[oJA<m>]; Run of the yarn carrier vertically o (- = insertion position, ^ = high position, v = deep position)
• The commands for the weave-in device are new