Operating Mode of the Machine: Tandem with Comb
Tandem with comb (CCC):
The knitting program (Sintral, Jacquard, Setup) is structured as follows:
- Both carriages function as one carriage with a wide space and with the system sequence:
- The yarn carriers for the left fabric piece are positioned in the left clamping and cutting device.
- The yarn carriers for the right fabric piece are positioned in the right clamping and cutting device.
- One yarn carrier knits-in the comb thread (elastic thread) over both fabric pieces due to the comb function at the start of the program.
- A Cast-off function is called-up at the fabric end.
Result:
Each piece is started with the comb and cast-off at the end.
Single fabrics are produced.
With this operating mode no fabric must be in the main take-down.
Make important settings for this operating mode:
- You are signed in as Senior Operator
. - Knitting program is loaded.
- 1
- In the main navigation bar switch to
Configure Machine. - 2
- Then, in the bottom navigation bar select
Options. - 3
- Open the tab.
- 4
- With the
Tandem with comb button activate the setting 
.
- The function is activated and the button is now displayed in yellow.
- The comb and clamping / cutting are activated.
- 5
- Create an order with a knitting program.