Machine Data

The machine data include the machine-specific settings (correction values).

They serve for the fine adjustment of the machine. The settings which are specific to the machine always remain saved, even after loading the operating system again.

Enter manually the machine data

If the current values of the machine data have got lost, and there is no dongle data available, then the data can be entered manually.

테이크 다운

Enter manually the correction values for the take-down.

Take-down

랙킹

Enter manually the correction values for the racking.

Racking

니들 선침

Enter manually the data of the needle selection displacement.

Enter the correction value for the upper comb position.

Comb

랙킹

Enter manually the correction values fort the three racking types.

Racking

니들 베드

  • Enter manually the position of carriage
  • Enter manually the needle selection offset

Needle Bed

케리지

  • Enter manually the correction values for the jack control.
  • Enter manually the correction values for the push pins.

Carriage

클램핑과 컷팅

  • Enter manually the correction value (NCCL) for the left yarn clamping and cutting device.
  • Enter manually the correction value (NCCR) for the right yarn clamping and cutting device.

클램핑과 컷팅

Enter manually the correction values (F, S, K) for the yarn clamping and cutting device.
(F)=TUCK, (S)=SELECTION, (K)=CLAMPING

You will find the correction values on the sticker (6).

This is necessary, for example, after replacing clamping and cutting device.

싱커

Enter manually the correction values for the holding-down jacks.