Assembling carriage part and carriage support

I. Put the carriage part on:

    1
    Mount the carriage part on the left or right outside the needle bed in such a way that it contacts the support surface (1).
  1. Moving the carriage part over the movable parts of the clamping and cutting bed, will push the parts into their correct position with the help of the cam curve.

 

 

Procedure

Front needle bed

  • Open the lateral safety door (on the right side).
  • Push the carriage part from outside onto the support surface (1).
  • Push the carriage part inward until it is located above the clamping and cutting bed.

Rear needle bed

  • Push both sliding boards in the same direction.
  • Position the carriage part on the support surface (1).

 

    2
    Deactivate the power supply 40 Volt .
    3
    Press the Release drive brake [>!] button below မန္န်ူရယ္ ေျဖရွင္းျခင္း 2
    4
    Push the carriage support exactly over the carriage part.
    5
    Screw in the shoulder screws (4) until the carriage part lifts slightly.
    2. 6
    Swivel the left and right swiveling plates (6) outward below the carriage support..
    7
    Tighten both shoulder screws (4) for fixing the carriage part.
    Assembly of the rear carriage part: pull the upper area of the carriage part (needle brushes) away from the needle bed to ensure that the shoulder screw does not cant.
    8
    Tighten screws (5) evenly.
    9
    Plug in the plugs (3) while watching the plug coding.
    10
    Tighten the screws at the plugs (3).
    11
    Mount the suction tubes again.
    12
    Assemble the carriage assembly panelling.
    13
    Close the covers.
    14
    Switch on the 40 Volt power supply.
    15
    Exit the window with OK.
    16
    In the main navigation bar select the main area Set up Order.
    17
    Then, in the bottom navigation bar select Intervene Manually I.
    18
    Press the Cancel Production [SPF S0] button.
  1. The knitting program is set to an empty row S0.
    19
    Start the machine with the engaging rod.
  1. The yarn carriers move automatically back into their knitting position, then the carriage starts moving.
    20
    Move the left carriage to the reversal point.
    21
    Switch needle selection on if necessary
    22
    With the Create Initial State button recover the initial state of the machine
    -  or  -
    Return to ေအာ္ဒါ တည္းျဖတ္ရန္ to re-start the order.
    23
    Tap the ေအာ္ဒါ စတင္ရန္ key.