Lubricate the Knitting Machine

Oiling and greasing:

You have to clean and lubricate the knitting machine regularly in order to maintain the operability of the knitting machine.

When a lubricating interval expires, a message appears:
Oiling or greasing

Use only the lubricants recommended by STOLL.
See operating instructions
Unsuitable lubricants may damage the machine.
Failure to comply will void the guarantee.

	Machine gauge	Designation
	E 3-14 E 2,5.2 - 7.2	Stolltex T46
E 16-18 E 8.2 - 9.2	Stolltex T32
After every tenth note appears to grease needle bed	Stoll Grease 475

Machine gauge

Designation

E 3-14

E 2,5.2 - 7.2

Stolltex T46

E 16-18
E 8.2 - 9.2

Stolltex T32

After every tenth note appears to grease needle bed

Stoll Grease 475

Lubricating intervals
6-10 operating hours	Oiling the needle bed without central lubrication. Note: Select a shorter interval if necessary.
10 operating hours	Oiling the jack bed, the thread clamping and cutting device and the yarn carrier rods.
100 operating hours	Oiling the carriage guide bar Oiling the needle latch hinges Greasing the pulse generator rails and the carriage guide Greasing the coupling parts and the intermediate sliders Greasing the yarn carrier rods
6 months	Greasing the racking device and needle bed supports

Lubricate with oil:

Lubricate with oil and grease:

Oiling the needle latch hinges:

1: Use a brush to apply oil to the needle latch hinges.

2: Knit with residual yarn until oil lines no longer appear in the fabric.

Observe the lubrication schedule in the operating instructions.

Set the lubrication interval for the needle bed:

The lubrication interval for the needle bed depends on:

Machine speed
Ambient temperature
Number of knitting systems

You are signed in as Senior Operator .
The knitting program is loaded and the production was started.

1: In the main navigation bar select Configure Machine.

2: Tap on Maintenance in the bottom navigation bar.

3: Open the Lubricate tab.

The following menu is displayed.

4: Press the Lubricate Knitting Area After button.

5: Via virtual keyboard, enter the desired value (a maximum of 60 000 run-throughs).

6: Confirm the entry with the OK button.

7: Button Stop Motion after Quantity of System Run-throughs:

Active : After reaching the lubrication interval, the machine stops.
Inactive : After reaching the lubrication interval, the machine is not stopped.

Note: Under ေခ်ာဆီ မထည့္မီ စနစ္၏ ထိုးခ်က္မ်ား is displayed the current state of the lubrication interval.