Create an order with one knitting program, wide couple the carriage assembly and set-up

Procedure:

1: Create an order with a knitting program.

2: Start production.

3: Interrupt the knitting program and set it to an empty row [SPF S0].

4: Couple the carriage assembly wide apart44“.

5: Check the settings under စက္ကို စီစဥ္သတ္မွတ္ရန္ / ေရြးခ်ယ္ႏိုင္ေသာ လုပ္ေဆာင္ခ်က္မ်ား in the လုပ္ေဆာင္ခ်က္မ်ား tab:

ဘီးျဖင့္ ႏွစ္ခုၿပိဳင္ လုပ္ေဆာင္ျခင္း: disabled
Result: Machine works without comb and clamping / cutting in tandem mode.
ဘီးျဖင့္ ႏွစ္ခုၿပိဳင္ လုပ္ေဆာင္ျခင္း: activated
Result: Machine works with comb, but not in tandem mode
Two fabrics will be produced side by side.

6: Start production again.

7: Prepare the machine and set-up the pattern

With Performer machine CMS 822:

Threading up the Yarn Carriers
Position the Yarn Carriers

8: Check the needle bed.
No fabric hanging in the needles?

With comb and clamping / cutting

No fabric in the needle bed

Without comb and clamping / cutting

The fabric must be in the needle bed
Start picking-up after pressing-off (#90) if necessary

9: Start the machine.

Make the following changes:

Cycle counters (RS)
Stitch Length (NP)
Fabric take-down values (WM, W+, WMK, …)
Yarn carrier staggering at the fabric selvedge (YD) with operating mode without comb