Replacing intermediate slider


There are different models depending on the machine type and the gauge.

Type 1

Valid for:

CMS 530
CMS 822
CMS 933
ADF
CMS 502 HP+
CMS 330
CMS 803

To replace the intermediate slider, you need a small pair of pliers.

Replacing the intermediate slider
Replacing the intermediate slider
    1
    Push the needle and coupling part (1) upward.
    2
    Using the pliers, pull the lower butt of the intermediate slider (2) downwards out of the needle bed while pressing the upper butt into the needle bed and pressing it under the cover rail (3).
    3
    Install the new intermediate slider in the reverse order.
    4
    Slide the needle and coupling parts into the home position.

Type 2

Valid for:

CMS 730 T

To replace the intermediate slider, you need a small pair of pliers.

Replacing the intermediate slider
Replacing the intermediate slider
    1
    Push the needle and coupling part (1) upward.
    2
    Push the intermediate slider (2) until the lower butt bumps into the cover rail (3).
    3
    Pull the upper butt of the intermediate slider out of the needle bed while pressing the lower butt into the needle bed and under the cover rail.
    4
    Install the new intermediate slider in the reverse order.
    5
    Slide the needle and coupling parts into the home position.

Type 3

Valid for:

CMS 830 C
CMS 520 C+

To replace the intermediate slider, you need a small pair of pliers.

Replacing the intermediate slider
Replacing the intermediate slider
    1
    Push the needle and coupling part (1) upward.
    2
    Push the spring wedge (3) to the side.
    3
    Pull out the intermediate slider (2) upwards.
    4
    Install the new intermediate slider in the reverse order.
    5
    Slide the needle and coupling parts into the home position.