Presser Foot Corrections ESCI in Setup

Command for machines with W presser foot

Weft Yarn Presser Foot Correction (ESCI)

ESCIn

49 correction values (indices) are available to activate or disable the presser foot

ESCIn: n= 1- 49
: ESCI 50 is used automatically for inverse plating with weft yarn presser foot.
Value range from -120nic to 120nic
Step width: 0.5 nic


: The shifting on and off depends on the direction of the carriage stroke!
	Activating the Weft Yarn Presser Foot
	Deactivating the Weft Yarn Presser Foot
0	Standard shift position
+	Later shift position
-	Earlier shift position

1: Tap on စက္ကို အသင့္ျပင္ဆင္ရန္ in the bottom navigation bar.
- or -
Tap on ပံုစံကို သတ္မွတ္ပါ.

3: Tap on ဘိ to open the window for modifying the presser foot correction value.


Name	List of the ESCI commands in use
Systems	On the machine only! The active knitting systems of the corresponding knitting row are displayed.
W ↓ +/-	Correction of the shift-in point for the weft yarn presser foot Positive value: Move the shift point in direction of the carriage Presser foot will be set down in delay. Negative value: Move the shift point in opposite direction of the carriage Presser foot will be set down in advance.
W ↑ +/-	Correction of the shift-off point for the weft yarn presser foot Positive value: Move the shift point in direction of the carriage Presser foot will be pulled-up in delay. Negative value: Move the shift point in opposite direction of the carriage Presser foot will be pulled-up in advance.

Correction values entered on M1plus will be applied by the technical processing to the parking of yarn carriers at the fabric selvedge.
Yarn carrier in the area for activating and deactivating will be displaced or in anticipation parked aside.
If the ESCI correction value is too high, the switch-on or switch-off area of the presser foot may be moved so far that the yarn carrier is in the active area of the presser foot. The technical processing will be canceled and the programmer has to solve the problem.

With entering the correction values in the Setup Editor at the machine may lead to an error message and machine stop.
Modify the values manually until error message will appear no more or edit the program on the M1plus again.