Setting: Cycle Counters
Use of cycle counters
- Cycle counters are used for the length control in a fabric piece
- Pattern areas are defined in the pattern and repeated by cycle counters (variables)
- The cycle counters are allocated to the corresponding pattern areas in the Sintral program.
- Possible variables of cycle counters:
- Setup: RS1 to RS39
Behavior of cycle counters
- Pattern without cycle counters
Result: The pattern cannot be influenced regarding the length.
- Same pattern with cycle counters
Result: The pattern can be changed regarding the length in the areas with defined cycle counters.
Call up and change used cycle counters in the Setup Editor
- You are signed in as Senior Operator
. - The knitting program is loaded and the production was started.
- 1
- Select
Prepare Machine in the bottom navigation bar and for changing the cycle counters, open the window with the 
Setup Editor / 
Cycle counter button.
- or -
select the
Set-up pattern window and for changing the cycle counters, open the window with the button. - 2
- Change the desired values.
| ||
RS | List of all the used cycle counters (RSn) | n = 1-39 |
Value… | Repetition factor | m = 1-9999 |
Comment | Designation of the cycle counter |
|
- 3
- With the
Close button exit the Setup Editor.
- Changed values in the Setup are saved together with the pattern when saving.