Avoid and Correct Errors

Yarn Feeding

ADF W	Adjust the yarn feeding to the weft yarn. The yarn carrier tip has to match the yarn.
	Use yarn carrier with bypass when: the yarn "sticks" in the yarn tube (1) Remedy: Use assembly kit bypass, see the yarn cannot be threaded in the yarn carrier tip (2). Remedy: Use "Yarn carrier carriage with bypass" kit, see Tip: Use additional yarn brake. The yarn brake prevents that the yarn tension arm (yarn control unit) pulls off yarn from the bobbin. See Yarn brake (ID 4170 266 739)
	Correct the position of the weft yarn carrier (YCI / YPI): (Edit the distance of the yarn carrier to the presser foot) (Setup Editor -> Yarn carrier menu -> YC/YCI tab or YPI tab) Set the weft yarn carrier higher (vertical correction) -> better guidance of the yarn in the presser foot groove
	Gauge range E10-E18: Increase the restoring force at the yarn control device. For this, assemble a yarn control unit of the coarser gauge range (E5-E8) (ID 4170 270 467).
CMS W	Adjust the yarn feeding to the weft yarn. If a bigger tip is needed then take a yarn carrier of a coarser gauge. Set the lateral yarn tensioner and the yarn control unit so that no loops are created at the fabric selvedge.

Knitting Technique

Execute the Border processing function so that the weft yarn is inserted at the fabric selvedge, see
Edit knitting-in and out of the weft yarn carrier, see
Enclosing of the weft yarn by transferring by alternating sides (1).
Possible problem: The weft yarn is catched when transferring.
Remedy: Before the spacing (2) stow the weft yarn carrier (3)
First narrowing then spacing (2) to prevent problems when transferring.
When knitting with high stitch tension, an area with NPJ in the Spacing (2) row may be favorable (set about 6/10 looser).
Adjust the weft yarn carrier via the yarn tension correction (Ka, Kb) to the knitting situation
(Setup Editor -> Yarn carrier menu -> YC/YCI tab)
Adjust the presser foot via the presser foot correction ESCI to the knitting situation, see and see.
(Setup Editor -> Presser foot menu)
If you enter a positive value in the W ↑ +/- column, the presser foot is later switched off. As a result, the weft yarn is held deep for longer.
ADF W: On a knitting-in presser foot adjust the values in the E ↑ +/-.
Ensure enough space for the weft yarn in the needle bed gap: