Maintenance Schedule - The Individual Tasks
All maintenance actions for all STOLL machines are listed here.
Different maintenance actions are necessary depending on the machine type.
Continuare informaţii
- Cleaning Suction Device
- Clean suction and lint container (ADF)
- Clean suction and lint container (CMS 830 S)
- Cleaning suction and lint container
- Cleaning the active thread clamp
- Oil selection jacks (CMS 830 S)
- Oil selection jacks
- Remove selection jack bed (CMS 520 C)
- Remove selection jack bed (CMS 830 C)
- CMS 830 C - Remove the needle rail
- Oiling the Wires in the Yarn Carrier Rail
- Lubricating the Yarn Carrier Bow
- Oiling yarn carrier rods
- Clean thread clamping and cutting device thoroughly (CMS 730 T)
- Clean thread clamping and cutting device thoroughly (CMS 830 S)
- Cleaning thread clamping and cutting device
- Cleaning thread clamping and cutting device
- Cleaning the friction feed wheel
- Grease butts of the coupling parts and intermediate sliders (CMS 830 S)
- Greasing butts of the coupling parts and intermediate sliders
- Greasing butts of the coupling parts and intermediate sliders
- Greasing butts of the coupling parts and intermediate sliders
- Oil butts of holding-down jack and transfer parts (CMS 730 T)
- Oiling lifting slide (yarn carrier plunger)
- Greasing impulse sensor rails
- Vacuuming the Interior on the Right Side
- Cleaning Comb Take-down and Belt Take-down
- Greasing the Linear Guiding
- Cleaning main drive fan
- Cleaning fan and radiators in right control unit
- Grease needle bed
- Thoroughly clean needle bed (CMS 730 T)
- Thoroughly clean needle bed (CMS 830 S)
- Thoroughly cleaning needle bed
- Oil needle bed
- Oil and grease needle bed
- Clean needle bed (CMS 830 S)
- Cleaning needle bed
- Cleaning needle bed
- Grease needle bed supports
- Check the oil collection tank
- Cleaning the permanent brakes
- Oil jack bed
- Cleaning Suction Fan
- Oiling carriage guide bar
- Greasing the control sliders (CMS 822)
- Greasing Brush Control
- Oiling the Control of Holding-down Jacks
- Cleaning the Knitting Machine
- Clean the knitting systems
- Clean the knitting systems
- Cleaning the touch screen
- Clean transport segment (CMS 730 T, CMS 830 S)
- Greasing racking device
- Cleaning the racking light barrier
- Oiling the Toothed Belts in the Yarn Carrier Rail
- Oiling the Toothed Belt
- Clean additional needle bed thoroughly (CMS 730 T)
- Cleaning additional needle bed