Greasing racking device
|
|
Stoll Grease 0475 |
|
|
Grease gun: |
- 1
- Position the rear needle bed at an angle (see Снять игольницу или установить ее наклонно).
- 2
- Remove the cover over the racking spindle.
- 3
- Apply grease on the racking strip and on the sliding guidances with a brush.
- 4
- Grease the lubricating nipple (1) with a grease gun (Grease: Klueber Staburags NBU 8 EP, ID 267 423)
Grease the racking device of the additional beds
- 1
- Remove the cover of the racking device on the right-hand side of the needle bed.
- 2
- Apply grease on the racking strip and on the sliding guidances with a brush.
- 3
- Grease the lubricating nipple (2) with a grease gun (Klueber Staburags NBU 8 EP, ID 267 423).
- 4
- Repeat the works on the left-hand side of the needle bed.