ADF - Double the quantity of yarn control units
Daha kaba ADF makineler (E5 - E8) için ikinci bir iplik iletim sistemi mevcuttur.
Özel tertibat (ID 283 754) şunlardan meydana gelmektedir:
- İplik yönlendirici sistem
- 32 iplik kontrol donanımı (ID 270 467)
- İplik iletim sistemi için 2 taşıyıcı
- İplik kontrol donanımları için bağlantı kablosu (ID 270 104)
Mounting the yarn guide device
Run the assembly with two people so that the yarn guide system is not damaged.
- 1
- Disconnect machine main switch.
- 2
- Unplug the cable at the signal lamp and at the yarn guide system.
- 3
- Dismantle signal lamp.
- 4
- Loosen the screws (1) on both side of the machine.
- 5
- Push the yarn guide system upwards together with somebody else, so that the support does not tilt.
- 6
- Put the yarn guide system down carefully beside the machine.
- 7
- Assemble the bow (2) on both sides of the machine in such a way that a gap (3) remains.
The previous yarn guide system is assembled again through this gap in the next step. 
- 8
- Assemble the previous yarn guide system again and screw it down with the screws (1) (see step 4).
- 9
- On both sides of the machine move the bow into the end position and screw it down.
- 10
- Assemble the new yarn guide system and screw it down.
- 11
- Assemble signal lamp.
- 12
- Open the right safety door.
- 13
- Unplug the XZ_6 plug and remove the previous cable.
- 14
- Plug the provided cable (ID 270 104) into the lower yarn guide system, upper yarn guide system and into the signal light.
- 15
- Plug the XZ_6 plug into the XZ_6 socket.
- 16
- Close the right safety door.
- 17
- Switch the machine main switch on again.