Adjust the Double Bow Plating Yarn Carrier

1

Central bow (fixed)

Plating Yarn

2

Follower bow (movable, following the central bow)

Basic Yarn

Central bow (1) - adjust height:

    1
    Loosen the screw (3) (turn by 90 degrees).
    2
    Adjust the central bow the same way as the normal yarn carrier.
    3
    Retighten the screw.

Follower bow (2) - adjust height:

    1
    Loosen both screws (4) (turn by 90 degrees).
    2
    Adjust the height turning the screw (5).
    Default setting: 2 mm higher than the central bow.
    3
    Retighten both screws (4).
    4
    Turn the screw (5) enough to prevent it from touching the upper or lower edge. If the screw is making contact, then the yarn carrier does not move smoothly and will be damaged.

Follower bow (2) - carry out the lateral adjustment:

    1
    A screw is located in the boring (6). Adjust it with an Allen key (2 mm) (Setting range: 0 - 2 mm).
    2
    The distance from the bow (2) to the bow (1) can be set individually on each side. A scale simplifies the setting of the distance.