Operating Mode of the Machine: Tandem without Comb
Tandem without Comb
The knitting program (Sintral, Jacquard, Setup) is structured as follows:
- The knitting program is generated for the left carriage with knitting systems S1 and S2. Needle selection is calculated internally for the left fabric piece and transferred to the right carriage, which produces the right fabric piece.
- A draw thread is knitted at the start of the program.
The draw thread enables to separate the pieces after knitting or ironing.
Result:
The fabrics are knitted as one piece, connected by the draw thread.
With this operating mode, a fabric must always be in the main take-down.
Important settings for this operating mode:
- You are signed in as Senior Operator
. - Knitting program is loaded.
- 1
- In the main navigation bar switch to
Configure Machine. - 2
- Then, in the bottom navigation bar select
Options. - 3
- Open the tab.
- 4
- With the
Tandem with comb button deactivate the setting 
.
- The function is deactivated and the button is now displayed in white.
- The comb and clamping / cutting are disabled.
- 5
- Create an order with a knitting program.