Detailed description

Repair yarn breakage:

    1
    At which yarn carrier did the yarn breakage occur?
    2
    Release the relevant yarn carrier.
    Tap on the required yarn carrier. The icon changes from to .
    Tap the yarn carrier again. The icon changes from to .
  1. The yarn carrier plunger is switched off.
  2. The home position of the yarn carrier is shown in the clamping and cutting bed (left or right) (Yellow rectangle).
    3. 3
    Tap in this area.
  3. The yarn carrier moves to the home position - certainly on the touch screen only.
    4. 4
    Repeat steps 2 and 3 if a yarn breakage occurred with several yarn carriers.
    5
    Push the respective yarn carrier by hand out below the carriage.
    6
    Thread-up yarn carrier.
    With a friction feed wheel: Switch on the respective feed wheel so that the yarn is running easily over the roller. Tap on the corresponding key Feed wheel.
  4. The feed wheel is switched on for 60 seconds.
    5. 7
    Switch on again the yarn carrier plunger.
    Select the yarn carrier (in the clamping and cutting bed) on the touch screen .
    Select the position in the needle bed (place holder) after this .
  5. The yarn carrier moves to the knitting position (certainly on the touch screen only).
  6. The yarn carrier plunger is switched on.
    7. 8
    Push the respective yarn carrier by hand below the carriage.
  7. It is positioned exactly if you here a "click". The yarn carrier is in the correct position below the carriage.
    8. 9
    Push the yarn end between the needle (needle cross) below the carriage.
    10
    Tap the (Khởi đầu ngắn gọn) key.
  8. The carriage moves a short distance (ca. 5 cm). The yarn is knitted-in.
    9. 11
    Tap on the button if you want to start another fabric (Khởi động lại vật dệt).
    The machine establishes a defined state and restarts the fabric after confirming. The piece counter does not count down because the actual fabric is defective.
    12
    Confirm the remedy of the yarn breakage (Xác nhận và đóng lại).
  1. The yarn breakage is repaired.

Pull up the engaging rod and continue production.