Needle Bed Distance

    1
    Call up 起头 tab -> 参数 group -> Pattern Parameters .
    2
    Select the Needle Bed Distance section.

Make the following settings in the Needle Bed Distance section:

1

General settings in the upper pane:


  • 默认 获取控制列默认条目到光标上。 将控制列单元格里的条目重置为默认值。

  • Delete the entry in the control column.

2

Settings in the table:

Entries 1 to 3 are pre-defined standard entries. These cannot be deleted or edited.

  • Small (1)
    Approximately the same distance as the standard machine.
  • Medium (2)
    Approximately the same distance as the multi gauge machine.
  • Large (3)
    Approximately the same distance as the k&w machine.