Lubricants and Cleaning Agents

Use only the lubricants found with the accessories of the machine or those listed in the lubricating schedule.

	Designation	Gauge
Oil	Stolltex T46 ID 268 621 (1 l) ID 268 622 (20 l)	E3│E3,5│E4│E5│E7│E8│ E2,5.2│E3,5.2│E5.2│E10│ E12│E14│E6.2│E7.2	Oil jack bed Oiling yarn carrier rods Oiling the Control of Holding-down Jacks Oiling carriage guide bar Oiling lifting slide (yarn carrier plunger) Oiling the Toothed Belt
Oil	Stolltex T32 ID 268 620	E16│E18│E20│E8.2│E9.2│E10.2
Grease	Stoll Grease 0475 ID 270 721		Greasing impulse sensor rails Greasing butts of the coupling parts and intermediate sliders Greasing the control sliders (CMS 822) Greasing racking device Grease needle bed supports
Grease	Grease gun: Klueber Staburags NBU 8 EP ID 267 423		Greasing racking device

Cleaning	Cleaning Cloth		Cleaning the Knitting Machine
		Special cleaning agent for Plexiglas (note the manufacturer's specifications)	Multi Touch Panel Covers
		Cleaning petrol (note the manufacturer's specifications)	Roller rubber of the take-down roller Belts of the belt take-down
	Industrial vacuum		Cleaning fan and radiators in right control unit
	Compressed air	No compressed air
	Groove cleaner		Thoroughly cleaning needle bed
	Do not use a magnet to remove metal particles		Thoroughly cleaning needle bed

NOTICE

Lubricating at running-in!

In the first weeks after setting up the knitting machine, select shorter lubricating intervals.

Inappropriate Lubricants!

Insufficient lubricating effect

Increased wear and tear

Sticking of the needle bed elements and the yarn carrier

Corrosion on metal parts

damage to the electrical cable insulation and the plastic parts.

No Magnets!

Needle bed or cams can get magnetized.

This can cause incorrect selection.

Do not remove metallic parts and fragments (e.g. broken needle latch or needle hook) with a magnetic tool.

Dirt-caked needle channels due to oil or cleaning agent!

When the needle channels are cleaned with oil or cleaning agent, the dirt swells up and clogs the needle channels.

Do not clean needle channels with oil or cleaning agent.
Push dirt out of needle channels and blow out needle channels with compressed air.

Solvents on Plastics!

Solvents can damage acrylic glass and other plastic surfaces.

Examples: Benzene, ethanol, alcohol

Plastics, in particular the transparent covers, may not be cleaned with glass cleaner or spirit.
Clean with pure water and dishwashing detergent only.
If necessary, clean with special detergent for acrylic glass.

Damage to the selection systems and impulse givers!

The selection systems and impulse givers will be damaged if they are cleaned with acetone or trichlorethylene (Tri).