Alarms of Machine Events

In this area you configure the threshold values for machine events in the alarm system.

1: In the Message area section of the Configuration window in the Stop motion number... field, enter one or more combinations from the machine status numbers and stop motion error numbers of the machine which the PPS is to interpret as a trigger regarding a stop motion.
Format: Machine status number[:[-]Error number,[-]Error number],...]; Machine status number [:[-]Error number,[-]Error number,...];… .
If only the machine status number is indicated, then all the error numbers will be considered for a message or alarm.

A machine state can also be considered only in case of simultaneous occurrence of message numbers. You enter the message numbers behind a machine state after a colon separated by a comma.

Una máquina siempre se encuentra en un estado que es representado por un estado de máquina y el cual tiene asignado un número.
Eventos de estado de MC y Estado de la máquina: Colores y símbolos
Los mensajes emitidos por la máquina también tienen este número.
Ayuda sobre mensajes de error.
Estos mensajes aparecen durante el estado de una máquina.

Puede hacer emitir un mensaje de PPS o alarma de PPS si la máquina adopta un estado o determinada combinación de estado y mensaje.

Combinations that already occurred can be found in the Event list report for EVENT_TYP=2 in the EVENT_PARAM field.
If no error numbers are indicated, then the machine status is always considered.
If a minus appears in front of the error number, it will be excluded and will not be considered for a message or alarm.

Example:

6;
Consider all message about Stop: Needle Position Sensor (6).
You want to be informed about all needle position sensor stops (6)
9:7250;
Consider the 07250 message only with Stop: Other (9)
With a machine stop for other reasons (9), the error number 7250 is to be on simultaneously for a message
10:-608,-1007,-10252;
Consider all message about Stop: Shock Stop Motion (10) except the 00608, 01007 and 10252 messages.
With a shock stop motion (10), you only want to be informed if it does not occur in combination with the error numbers 608, 1007, and 10252.
Via the Event list in the Excel report or in the report integrated in the PPS you can filter by EventType=2 and EventID=2...32002. The Event ID corresponds to the machine state number.
In the EVENT_PARAM column, you can see which error numbers the machine delivers and determine the appropriate numbers for filtering.
The error numbers are also displayed in the message area of the machine.
You can see the message numbers in the Stop Motions and Warnings dialog box at the machine.
Or here: Ayuda sobre mensajes de error
Note, that OKC and EKC machines use different numbers for the same message.

1: Select the Save button.

In the Configurar notificaciones individuales del usuario mask, you can book the events that are described below via the Machine events event.

The alarm configuration of machine events will be implemented immediately.