Setup Mode

The setup mode is only available for orders with several knitting programs (positions).

Handling of the setup mode:

  1. You are signed in as Senior Operator .
  2. The yarn carriers are in the collecting clamp unit and are clamped.
  3. The order is created with several knitting programs.
    1
    In the dialog box select the first position (knitting program).

1

List of all loaded knitting programs (positions) in the sequence of production.

2

Changing of the knitting order with the / buttons.

: Select the knitting program to be moved.

3

Information for

  • Sintral (sin)
  • Jacquard (jac)
  • Setup (setx)

4

Piece counter for the corresponding position (knitting program)

5

Quantity of run-throughs for the entire order (all listed knitting programs)

6

Start the setup mode

7

Start Production

 

    2
    Start the setup of the first position (knitting program) with the သတ္မွတ္ စနစ္ button.
    3
    Change to စက္ကို အသင့္ျပင္ဆင္ရန္ in the bottom navigation bar.
  1. The yarn carrier home position for the first knitting program is displayed.
    4
    Thread-up yarn carrier.
    5
    Start machine (engage) and knit.
    6
    Control all pattern parameters during the knitting and change them if necessary.
  1. The machine stops automatically at the end of the first knitting program in the left reversal.
  2. The cause of the stop motion is displayed.
    7
    In the Stop Motions and Warnings dialog box press the button.
  1. The Order complete dialog with the options to continue working is displayed.

1

Rotate fabric take-down forward to cast-off the fabric

2

Exit the setup mode to start the production

3

Knit-off again the position (knitting program) for another control

4

Select the next position and start the knitting program

    8
    If necessary, cast-off the fabric piece with the အထည္ ဖယ္ရွားစနစ္ကို ေရွ႕သို႔ လွည့္ပါ button.

Check the fabric piece to verify if the desired quality was achieved.

    9
    Inspection of the fabric piece:
  1. Not ok
    Proceed by the အထည္ကို ျပန္ထုတ္လုပ္ရန္ button.
  2. ok
    Proceed by the အေနအထား ေနာက္တစ္ခု button.
    10
    When changing to the next position (new knitting program), if necessary, in the bottom navigation bar go again to စက္ကို အသင့္ျပင္ဆင္ရန္, to check the yarn carrier home position for this knitting program.
    11
    If necessary, thread-up the added yarn carriers.
    12
    Continue with this sequence until all positions (knitting programs) are appropriate for the production.
    13
    After running-through all positions of the order exit the mode with the သတ္မွတ္ စနစ္မွ ထြက္ရန္ button.
    14
    Exit the dialog with the ပယ္ဖ်က္ရန္ button and return to the main window.