Clean the knitting systems

    1
    Stop the knitting machine.
    2
    Move the carriage assembly into the left reversing position.
    3
    Set the main switch to 0 and wait until the touch screen is switched off.
    4
    Remove the carriage part.

THÔNG BÁO

notice

Damage to the knitting systems!

Dirt will be blown into the guides of the movable parts and the knitting systems will be damaged if they are blown out with compressed air.

  1. Always vacuum off the knitting systems, never blow them out.
    5
    Vacuum off the knitting systems and selection systems.

THÔNG BÁO

notice

Hệ thống lựa chọn và bộ tạo xung sẽ bị hư!

Hệ thống lựa chọn và bộ tạo xung sẽ bị hư nếu vệ sinh bằng acetone hoặc trichloreothelene (Tri)

  1. Lau sạch hệ thống lựa chọn và cảm biến xung lực bằng vải sạch.
    6
    Clean the selector systems and impulse sensors with a clean cloth.
    7
    Check the cams for wear and damage.
    8
    Apply oil onto the cams with a brush.
    9
    Set the carriage part on the needle bed again.
    10
    Repeat step 4 to 9 for all carriage parts.
    11
    Set the main switch to 1.
  1. The carriage position is re-referenced.