Direct Installation: Installation and Configuration

Perform installation and configuration:

    1
    While the Warmstart is running, press one of the buttons, for ex. under Installation path (1) to specify the source directory for the software installation.
  1. The automatic warm start will be canceled.
    2
    Under (1) select one of the 3 presettings.
    3
    If necessary, change the path of the source directory via the corresponding button.
    4
    Select the desired installation:

Result:
A message Install new version with the version to be installed is displayed.

    5
    Force Installation :
    Install the operating system completely new or repair it.
    Not recommended!! (takes a long time)
    - or -
    Force Installation :
    Quickly install the changed data.

If the language file eknitlang is in the same directory as the operating system, this file is installed automatically.
Can also be installed afterwards.

    6
    To confirm tap the Yes button.
  1. The installation process gets started.
  2. The menu Installer is automatically closed and the next menu is displayed.

 

    7
    According to the machine gauge the Knit and wear machine button
    8
    Activate the Knit and wear machine button.
    9
    Go to the next setting with the Continue button.

 

    10
    With the (2) button select the following:

The selection only is possible if the Knit and wear machine button was activated.

    11
    Go to the next setting with the Continue button.
  1. 12
    With or select the desired Needle gauge.
    13
    Go to the next setting with the Continue button.

 

    14
    With or select the desired Needle hook gauge.
    15
    Go to the next menu with the Continue button.

Feed Wheel on the Left Present

  • : Yes
  • : No

Feed Wheel on the Right Present

  • : Yes
  • : No

Number of clamping and cutting points on the left

Number of clamping and cutting points on the right

Auxiliary Take-down

  • : Yes
  • : No

Belt Take-Down

  • : Yes
  • : No

Central lubrication

  • : Yes
  • : No

Suction

  • : Yes
  • : No

 

Yarn Carrier Drive

  • Type 1
  • Type 2

 

    16
    Via the respective buttons enter the corresponding machine configuration.

Machine fault!
The presence or lack of machine options must correctly be specified, as otherwise a fault may occur on the machine.

    17
    Go to the next menu with the Continue button.

 

    18
    Make the desired setting with the  Produce Technical Fabrics button:
    19
    Go to the next menu with the Continue button.
  1. The menu Reference Machine is opened.
    20
    More in the next chapter Reference runs.