Couple Carriage Assembly Wide

  1. You are signed in as Senior Operator .
  2. A knitting program is loaded.
    1
    In the main navigation bar select Set-up Order.
    2
    Open Edit order in the bottom navigation bar.
    3
    Press the Exit production button:
  1. The loaded order was completed.
    4
    If necessary, save the order.
    5
    Select Intervene Manually I in the bottom navigation bar.
    6
    Tap the Cancel Production [SPF S0] button.
  1. If the loaded order was not yet saved, a prompt appears for saving the changes and the machine is set to an empty row.
    7
    If necessary, save changes.
    8
    Start the machine with the engaging rod and stop it again when the carriage is located shortly after the left reversing position.
    9
    In the main navigation bar select the main area Maintain Machine.
    10
    Select Service in the bottom navigation bar.
    11
    With the Carriage button, open the Service Functions for the Carriage menu.
    12
    With 40 Volt deactivate the setting .
  1. The power supply 40 V is deactivated and the button is now displayed in white.
    13
    If necessary, press the Release drive brake [>!] button.
  1. The carriage assembly can be moved manually.
    14
    Open and remove the rear panel segments.
    15
    Loosen screws (2) and remove coupling rod (1).
    16
    For wide coupling (tandem machine), push the right carriage to the right until the coupling rod (1) can be assembled.
    17
    Insert the screws (2) and tighten.
    18
    Remove the carriage part in order to replace the cams.

 

In caso di ulteriore accoppiamento sostituire, per ragioni di sicurezza, le camme.

    19
    Place carriage part on contact surface and assembly with carriage assembly.
    20
    Close the rear panel.
    21
    In the main navigation bar select the main area Maintain Machine.
    22
    Select Service in the bottom navigation bar.
    23
    With the Carriage button, open the Service Functions for the Carriage menu.
    24
    With 40 Volt activate the setting .
  1. The power supply 40 V is activated and the button is now displayed in yellow.
    25
    With the OK button return to the previous window.
    26
    Engage machine.
  1. The machine stops and the Coupling width ? error appears.
    27
    Engage the machine for executing the reference run
  1. The reference run is executed to know the used coupling width.