Central lubrication

Starting with the 2023 change of component time, the ADF and CMS machines are equipped with a central lubrication as a standard equipment.

If a central lubrication is mounted on the knitting machine you can switch it on and off.
Central Lubrication - Differences of Type 1, Type 2 and Type 3

Central lubrication disabled

Needle bed
System Run-throughs Until Lubricating Process	Displays the quantity of the system run-throughs until the next oiling of the needle bed.
Confirm Oiling the Needle Bed	Click this button only if the oiling process actually was performed.
Confirm Greasing the Needle Bed	Click this button only if the greasing process actually was performed.

With Restart and Configuration, you can select the central lubrication as option.

No.	Function
1		자동 오일 공급
			inactive
			Active
2	Three settings are available for the lubrication interval:
	초기 기름주기 This setting is used for the initial lubrication of a new machine at the Stoll factory. The values cannot be modified. Attention: Risk of soiling the fabric Select this setting for approx. 15 minutes After a gauge conversion After a complete standstill of the machine
	STOLL 사양 Use this setting for production. The values cannot be modified.
	사용자 설정 The user can change the values. Attention: An improper setting could lead to insufficient oiling. Ensure that the central lubrication applies sufficient oil to the needle bed.
3		Input of the desired value (system run-throughs) for the lubrication interval for후에 편직 영역 윤활
4		Input of the desired value (number of lubrication procedures) for the lubrication interval 후에 전체 니들베드 윤환
5		Number of system run-throughs since the last lubrication process. 윤활 진행까지 시스템 회전

5: Make further desired settings for the lubrication interval of the central lubrication.

Only CMS 5xx / 5“ with central lubrication type 1 and 2

For mechanical reasons, the central lubrication does not reach all eight clamping positions.