Presser foot reference run
Weave-in device reference run - What must be observed?
- The carriage must be located in the needle bed. Otherwise, there is the danger of the weave-in device being damaged by the clamping and cutting bed.
- Stop the carriage at a point in the needle bed, where no yarn carrier is located.
For doing this, proceed as follows:
- You are signed in as Senior Operator.
- 1
- Open the 프레져 풋 menu.
유지보수 기계 -> 
서비스 -> 
프레져 풋
- 2
- Tap the button 레퍼런스 진행 (2).
주목
Damage of the weave-in device!
No yarn carrier may be in the area of the weave-in device - the presser foot and yarn carrier may get damaged.
- Push the yarn carriers aside so that the weave-in devices can carry out the reference run (high-deep movement).
- 3
- If there is no yarn carrier in the area of the presser foot, then tap the 예 button.
- 4
- The reference run will be carried out automatically. All weave-in devices will be referenced one after the other.
- During the reference run, the 레퍼런스 진행 button is greyed out.
- Once the reference run is complete, the 레퍼런스 진행 button will be active again.
