Lubricating

수동 윤활

This button is active if the machine is equipped with central lubrication.

Switch on or off the central lubrication.

Active button = The central lubrication is switched off.

If the central lubrication is switched off you must lubricate the needle bed and jack bed manually.

Inactive button = The central lubrication is switched on.

윤활 진행까지 시스템 회전
  • Set the quantity of system run-throughs until the next oil lubrication is required (n=1-65535).
  • Displays the quantity of the remaining system run-throughs until the next oiling of the needle bed.

시스템 회전 수량 후 정지

Active button = The machine stops after reaching the system run-throughs.
At the display appears the message Lubricate needle bed.

Check the oil collection tank

  • Set quantity of days until the next control of the oil collection tank (n=1-180)
  • Display of the time (in days) until the next control of the oil collection tank.

수동 윤활

Active button = The central lubrication is switched off.

If the central lubrication is switched off you must lubricate the needle bed and jack bed manually.

Inactive button = The central lubrication is switched on.

자동 오일 공급

Switch on or off the central lubrication.

If the central lubrication is switched off you must lubricate the needle bed and jack bed manually.

If you tap on the icon , you can select one of the following options:

초기 기름주기

This setting is used for the initial lubrication of a new machine at the Stoll factory.
The values cannot be modified.
Caution: risk of soiling the fabric.

Select this setting for approx. 15 minutes:

STOLL 사양

This setting can be used for production. The values cannot be modified.

사용자 설정

The following buttons are activated, the values can be modified:

  • 후에 편직 영역 윤활
  • 후에 전체 니들베드 윤환

Attention
An improper setting could lead to insufficient oiling. Ensure that the central lubrication applies sufficient oil to the needle bed.

후에 편직 영역 윤활

시스템 진행

Set the quantity of system run-throughs until the next oil lubrication is required (n=1-65535).

후에 전체 니들베드 윤환

윤활 진행

Setting of the number of lubrication procedures after which the entire needle bed is to be lubricated.

윤활 진행까지 시스템 회전

Displays the quantity of the remaining system run-throughs until the next oiling of the needle bed.

후에 편직 영역 윤활

시스템 진행

Set the quantity of system run-throughs until the next oil lubrication is required (n=1-65535).

시스템 회전 수량 후 정지

Active button = The machine stops after reaching the system run-throughs.
At the display appears the message Lubricate needle bed.

윤활 진행까지 시스템 회전

Displays the quantity of the remaining system run-throughs until the next oiling of the needle bed.