Remove the carriage part to replace cams

I. Remove the carriage part from the needle bed

Central lubrication

If a central lubrication is present, swivel it into mounting position.

    1
    Move the carriage assembly outward up to the support surface.
    2
    Deactivate the power supply 40 Volt .
    3
    Remove the carriage assembly panelling (1).
    2. 4
    If the rear carriage part is removed, the needle detector is to be removed as well.
    3. 5
    Mark the position of the needle detector so that it can be reassembled in the same position.
    6
    Remove the suction tube on the carriage assembly.
    7
    Remove the shoulder screws (2) and screws (4) on the left and right-hand sides.
    4. 8
    Swivel left and right swiveling plates (5) inward.
    5. 9
    Loosen the screws on the plugs (3) and pull out the plugs.
    10
    Press the Release drive brake [>!] button below မန္န်ူရယ္ ေျဖရွင္းျခင္း 2
    11
    Push away the carriage assembly.

If the carriage assembly is blocked:

The drive brake has automatically closed.

    12
    Lift the carriage part off the support surface.
    -  or  -
    Open the side safety door hood and lift out the carriage part to the side.
    13
    To replace the cams, turn the cam plate upward.