Central lubrication

Starting with the 2023 change of component time, the ADF and CMS machines are equipped with a central lubrication as a standard equipment.

If a central lubrication is mounted on the knitting machine you can switch it on and off.
Central Lubrication - Differences of Type 1, Type 2 and Type 3

Central lubrication disabled

The monitoring of the lubrication interval is automatically activated.
The following lubrication tasks must be performed manually:

Oil needle bed
Oil jack bed
Oiling carriage guide bar

Needle bed
System Run-throughs Until Lubricating Process	Displays the quantity of the system run-throughs until the next oiling of the needle bed.
Confirm Oiling the Needle Bed	Click this button only if the oiling process actually was performed.
Confirm Greasing the Needle Bed	Click this button only if the greasing process actually was performed.

Activate the central lubrication:

With Restart and Configuration, you can select the central lubrication as option.

You are signed in as အႀကီးတန္း စက္ေမာင္း .

1: Select စက္ကို စီစဥ္သတ္မွတ္ရန္ in the main navigation bar.

2: Tap on ထိန္းသိမ္းမႈ in the bottom navigation bar.

3: Open the ေခ်ာဆီထိုးျခင္း tab.

The following menu is displayed.

No.	Function
1		အလယ္ပိုင္း ေခ်ာဆီထိုးစနစ္
			inactive
			Active
2	Three settings are available for the lubrication interval:
	ကနဦး ေခ်ာဆီထိုးျခင္း This setting is used for the initial lubrication of a new machine at the Stoll factory. The values cannot be modified. Attention: Risk of soiling the fabric Select this setting for approx. 15 minutes After a gauge conversion After a complete standstill of the machine
	STOLL သတ္မွတ္ခ်က္မ်ား Use this setting for production. The values cannot be modified.
	သံုးစြဲသူ ဆက္တင္မ်ား The user can change the values. Attention: An improper setting could lead to insufficient oiling. Ensure that the central lubrication applies sufficient oil to the needle bed.
3		Input of the desired value (system run-throughs) for the lubrication interval forသတ္မွတ္အခ်ိန္ေက်ာ္လွ်င္ သိုးေမြးထိုးသည့္ ေနရာကို ေခ်ာဆီထည့္ရန္
4		Input of the desired value (number of lubrication procedures) for the lubrication interval ၿပီးေနာက္ အပ္မ်က္ႏွာျပင္ တစ္ခုလံုးကို ေခ်ာဆီထိုးပါ
5		Number of system run-throughs since the last lubrication process. ေခ်ာဆီ မထည့္မီ စနစ္၏ ထိုးခ်က္မ်ား

4: Activate the central lubrication with အလယ္ပိုင္း ေခ်ာဆီထိုးစနစ္ button.

5: Make further desired settings for the lubrication interval of the central lubrication.

Oil the clamping and cutting device on the right

Only CMS 5xx / 5“ with central lubrication type 1 and 2

For mechanical reasons, the central lubrication does not reach all eight clamping positions.

1: Use a brush to apply oil to all working butts of the clamping points.