Clean the Suction and the Control Unit (starting with component type 01)

I. Clean the lint container and the suction turbine:

    1
    Stop knitting machine when carriage is located on right half of needle bed.
    2
    Slide on cover over needle bed.
    3
    Push locking of lint container inwards and pull away container upwards.
    2. 4
    Empty the lint container.
    5
    Clean filter (1) of lint container.
    6
    Reinstate the lint container.
    7
    Remove left rear panel segment.
    8
    Clean motor cover.

II. Clean the suction tube:

Damage of the suction tube!
The suction tube will be damaged at the coupling point suction tube-hose if you lift it by the suction nozzle.

Lift the suction tube always in the middle so that the coupling point of suction tube and hose is separated

    1
    Lift the suction tube in the middle until the fixing clip is pulled out of the carriage.
    2. 2
    Blow out the suction tube with compressed air.

III. Cleaning at the right control unit:

    1
    Switch off machine.
    Set the main switch to 0 and wait until the touch screen is switched off.
    2
    Swing open the cover on the right control unit.
    2. 3
    Vacuum-off and blow-out the fan (1) and heat sink (2).
    4
    Close the cover on the right control unit.