Clean the knitting systems

Stolltex T46

E3│E3,5│E4│E5│E7│E8│E2,5.2│E3,5.2│E5.2│
E10│E12│E14│E6.2│E7.2

Stolltex T32

E16│E18│E20│E8.2│E9.2│E10.2

    1
    Stop the knitting machine.
    2
    Move the carriage assembly into the left reversing position.
    3
    Set the main switch to 0 and wait until the touch screen is switched off.
    4
    Remove the carriage part.

ATENŢIE

notice

Damage to the knitting systems!

Dirt will be blown into the guides of the movable parts and the knitting systems will be damaged if they are blown out with compressed air.

  1. Always vacuum off the knitting systems, never blow them out.
    5
    Vacuum off the knitting systems and selection systems.

ATENŢIE

notice

Deteriorarea sistemelor de selectare şi a senzorului de impulsuri!

Sistemele de selectare şi senzorul de impulsuri pot fi deteriorate, dacă sunt curăţate cu acetonă sau cu tricloretilenă (TRI).

  1. Sistemele de selectare şi senzorul de impulsuri se curăţă cu o pânză curată.
    6
    Clean the selector systems and impulse sensors with a clean cloth.
    7
    Check the cams for wear and damage.
    8
    Apply oil onto the cams with a brush.
    9
    Set the carriage part on the needle bed again.
    10
    Repeat step 4 to 9 for all carriage parts.
    11
    Set the main switch to 1.
  1. The carriage position is re-referenced.