Pattern design technique on the CREATE PLUS

Create FlexPly Pattern

  1. CREATE PLUS version V2.4. – 04/2023 or higher.
  2. ADF machine E 7.2 with cam box conversion for FlexPly
    1
    Open a new pattern.
    2
    Select an ADF machine E 7.2 with cam box conversion for FlexPly.
    3
    Open the Атрибуты машины tab.
    4
    Select FlexPly setting in the Функции системы section under Преобразование системы.
  1. In the Функции системы section, the system functions are automatically adjusted.
    2. 5
    Confirm the prompt with ОК.
    The system conversion for 'FlexPly' will be activated!
    6
    Open the Цвета платировки tool window.
    Цвета платировки
    7
    Define a plating color by Цвета нитеводителей.
    Plating Color P1:
    Column A: Yarn carrier color 8 for the binding thread
    Column B: Yarn carrier color 7 for the motif thread
    8
    Allocate the necessary plating index to the yarn carrier colors.
    9
    Draw pattern.
    The FlexPly motif can be done on the rear, front or on both needle beds.
    Draw with plating color and the following needle action e.g:
    Enter Петля сзади only.
  2. Resulting "Stitch-Float"
    3. 10
    Or enter Motif Thread at Rear and Петля сзади.
  3. Resulting "Stitch-Stitch" for motif thread and binding thread.
  4. E.g. for the rear needle bed:
    5. 11
    Entry the FlexPly front and rear function in the Системная функция control column.
    12
    Execute Обработка- Техники.
    13
    Check the knitting program with the Sintral-Check Check.

Recommended for FlexPly:

  • Use yarn carriers of inner yarn carrier tracks.
    Example for ADF 32:
    • Yarn carrier 8 for the binding thread
    • Yarn carrier 7 for the motif thread
  • Set the plating index (YPI) in the Setup Editor.
    • Leading (binding thread)
      Insert Position: -6.5
      Height : 0
    • Following (motif thread)
      Insert Position: 6.5
      Height : 0
  • Floating length
    Not more than 1/2 inch