Central lubrication

Starting with the 2023 change of component time, the ADF and CMS machines are equipped with a central lubrication as a standard equipment.

Central lubrication disabled

Needle bed

System Run-throughs Until Lubricating Process

Displays the quantity of the system run-throughs until the next oiling of the needle bed.

Confirm Oiling the Needle Bed

Click this button only if the oiling process actually was performed.

Confirm Greasing the Needle Bed

Click this button only if the greasing process actually was performed.

Activate the central lubrication:

With Restart and Configuration, you can select the central lubrication as option.

  1. You are signed in as Người điều hành cao cấp .
    1
    Select Cấu hình máy in the main navigation bar.
    2
    Tap on Bảo trì in the bottom navigation bar.
    3
    Open the Bôi trơn tab.
  1. The following menu is displayed.

No.

Function

1

Trung tâm bôi trơn

inactive

Active

2

Three settings are available for the lubrication interval:

Bôi trơn ban đầu

This setting is used for the initial lubrication of a new machine at the Stoll factory.
The values cannot be modified.

Attention:

  • Risk of soiling the fabric
  • Select this setting for approx. 15 minutes
    • After a gauge conversion
    • After a complete standstill of the machine

STOLL Chỉ định

Use this setting for production.
The values cannot be modified.

Cài đặt người dùng

The user can change the values.

Attention:

  • An improper setting could lead to insufficient oiling.
  • Ensure that the central lubrication applies sufficient oil to the needle bed.

3

Input of the desired value (system run-throughs) for the lubrication interval forBôi dầu khu vực dệt sau khi

4

Input of the desired value (number of lubrication procedures) for the lubrication interval Bôi dầu toàn bộ giường kim sau khi

5

Number of system run-throughs since the last lubrication process.
Hệ thống lượt chạy tới lúc quá trình bôi trơn

    4
    Activate the central lubrication with Trung tâm bôi trơn button.
    5
    Make further desired settings for the lubrication interval of the central lubrication.

Oil the clamping and cutting device on the right

Only CMS 5xx / 5“ with central lubrication type 1 and 2

For mechanical reasons, the central lubrication does not reach all eight clamping positions.

    1
    Use a brush to apply oil to all working butts of the clamping points.