What was new in OKC 2.6?

The most important changes in this version:

YLC - Yarn disposition
The Yarn disposition window was re-designed.
The table displays the following data:

Yarn consumption of all the knitted pieces (individual pattern, sequence, sequence element, sequence list, order menu)
Yarn consumption of the last knitted piece
Yarn consumption of the current piece
Yarn consumption of the individual measuring wheels

YLC5 – Minimum width with higher gauges
With some patterns appeared the problem that it was not possible to determine the data for the original fabric (Master Piece) without errors. The reason was the inaccuracy of the measuring, caused by a very changing yarn tension when catching up the yarn in the carriage reversal.
Therefore the minimum width was increased from 5 to 6 inches (gauge E16, E18, E8.2 and E9.2).
The minimum width with the gauges E3 to E14 will continue being 5 inches.

The minimum width is adjustable for all gauges:
Setup2-Editor -> Stitch length menu -> YLC5 tab

What do you need to take care of with the existing patterns with gauge E16, E18, E8.2 and E9.2?

If you were able to knit your pattern without problems up to now, change the minimum width in the YLC5 tab to 5 inches. See, section YLC5.
If you do not change the minimum width, you need to knit the original fabric again.

YLC regulation for gauge E 2,5.2
Up to now: The YLC regulation was adjusted the same way as with higher gauges.
New: With gauge E2,5.2 the regulation is now carried out as fast as with coarse gauges (E3 – E4)