1. ASCON - YLC MM + MP
  2. How to Use the Yarn Length Control
  3. Mesurer et corriger la longueur du fil
  4. Working with mm (millimeters)
  5. Individual correction values for each knitting mode

Individual correction values for each knitting mode

You can assign a separate correction value to each knitting mode.

In order to prevent the calculation of correction values from being distorted when using the operating mode Working with mm (YLC MM), individual knitting rows and smaller knitting areas should not be included in the calculation. These include for ex. the net row in the cuff, knit-in rows, small stripe patterns, cuffs with reduced height, etc.

M1plus

Pattern workstation:

  • Working with mm operating mode
  1. In the pattern and the Setup Editor, determine a separate stitch length (NP value) in mm for each knitting mode.
    Value [mm]
  1. Specify the Working with mm operating mode.
  1. Exclude the start and special knitting areas with YLC- from the yarn length control, if necessary.
EKC

EKC machine

  1. Select the Working with mm operating mode.
    Installer l'ordre Installer le dessin En généraltab Type de fonctionnement pour dessin
  1. Call up the NP / Roue tab.
  1. Activate the desired knitting mode with the assigned NP value to determine the correction values.
  1. Deactivate the knitting modes excluded from measuring and correcting.
  1. Open the Contrôle de la longueur du fil window.
    Produire l'ordre Contrôler la production Contrôle de la longueur du fil
  1. Activate Déterminer les conditions de base.
  1. Re-start knitting the fabric piece to determine the basic conditions.
    Produire l'ordre Intervenir manuellmt I Recommencer le panneau
  • The corrections for the NP values of the selected knitting modes are determined.
OKC

OKC machine

  1. Activate the Operating mode for patternsfield.
  1. Select the Working with mm operating mode.
  1. Call up the NP (knitting mode) / Wheel tab.
  1. Activate the desired knitting mode with the assigned NP value to determine the correction values.
  1. Deactivate the knitting modes excluded from measuring and correcting.
  1. Start the machine.
  • The correction values for selected knitting modes are determined.