REC – learning phase: Determination of the correction values before the production is started.
You can make greater corrections in the learning phase.
The current fabric can get unusable if the corrections are very great.
You can repeat the learning phase several times if necessary. Therefore keep the Determine Basic Conditions button activated.
Stitch lengths will be measured with the values defined in the knitting program.
A separate correction value is determined for each carriage direction.
A separate NP value is determined for each knitting mode. This way a separate correction value can be determined.
Production
If the pattern meets your expectations, apply the correction values (actual values). For this purpose, activate the Production switch.
Differences between the bobbins are compensated.
The stitch cams will automatically be controlled during the production, if necessary. At first larger corrections are possible, for the following pieces, the corrections become smaller.
The ASCON device controls in small steps so that a change of the stitch length is hardly visible within the fabric. If one yarn carrier is seldom in action and the correction is very large, then the first fabric and in an unfavorable case even further fabrics may be unusable.
